Section
5
Fire
and
Explosion
Hazard
Flash
Point:
164°F
/
73°C
(Method): P.M.C.C.
Auto Ignition Temperature:
Not Determined.
Flammability Limits in Air:
Not Determined.
Extinguishing Media:
All standard firefighting media.
Hazardous Decomposition Products:
This product contains methyl-polysiloxane which can generate formaldehyde at
approximately 300°F (150°C) and above in atmospheres that contain oxygen. Other
decomposition products are carbon oxides, nitrogen oxides and silica (crystalline).
Section
6
Accidental
Release
Measures
Containment/Clean-Up:
Disposal of collected product, residues, and clean-up materials may be governmentally regulated.
Observe all applicable local, state and federal waste management regulations. Mop up, wipe up, or soak up
with absorbent and contain for salvage or disposal. For large spills, provide diking or other appropriate
containment to keep material from spreading. Clean any remaining slippery surfaces by appropriate
techniques, such as several moppings or swabbings with appropriate solvents; washing with mild, caustic
detergents or solutions; or high-pressure steam for large areas. For non-silicones, use typical industrial
cleaning materials. Observe any safety precautions applicable to the cleaning material being used.
Observe all personal protection equipment recommendations described in Section 8. Local, state and
federal reporting requirements may apply to spills or releases of this material into the environment. See
applicable regulatory compliance information in Section 15.
Note:
See Section 8 for Personal Protection Equipment for Spills.
Section
7
Handling
and
Storage
Handling:
Use with adequate ventilation. Avoid eye contact.
Storage:
Keep container closed and away from heat, sparks and flame.
Section
8
Exposure
Controls/Personal
Protection
Engineering Controls:
Local Exhaust:
None should be needed.
General
Ventilation:
Recommended
Personal Protective
Equipment for Routine
Handling: Eyes:
Use
proper
protection (safety glasses as a minimum).
Skin:
Washing at mealtime and end of shift is adequate.
Suitable
Gloves:
No
special
protection
needed.
Inhalation:
No
respiratory protection should be needed.
Suitable
Respirator:
None
should
be
needed.
Personal Protective
Equipment
for
Spills:
Eyes:
Use
proper
protection (safety glasses as a minimum).
Skin:
Washing at mealtime and end of shift is adequate
Inhalation/Suitable
Respirator:
No
respirator protection should be needed.
Precautionary Measures:
Avoid eye contact. Use reasonable care.
Comments:
None
Note:
These precautions are for room temperature handling. Use at elevated temperatures, or in aerosol/spray applications, may
require added precautions.
Page No. 2 of 3 MSDS JEESILC 74
24 Madison Road, Fairfield, New Jersey 07004, USA
Tel: 800-771-JEEN (5336), Tel: 973-439-1401, Fax: 973-439-1402,
email:
info@jeen.com
, Website:
www.jeen.com
