SECTION
VII
-
SPILL
OR
LEAKAGE
PROCEDURES
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED:
IF THE PRODUCT IS IN A SOLID STATE SHOVEL DIRECTLY INTO RECOVERY DRUMS. IF THE PRODUCT IS A LIQUID
IT SHOULD BE PICKED UP USING A SUITABLE ABSORBENT MATERIAL THEN SHOVELED TO RECOVERY DRUMS.
DISPOSE OF D INCINERATION, LANDFILL, OR ANY OTHER METHOD WHICH IS IN COMPLIANCE WITH LOCAL,
STATE, AND FEDERAL REGULATION.
WASTE
DISPOSAL
METHOD:
SECTION VIII- SPECIAL PROTECTION
INFORMATION
RESPIRATORY PROTECTION
(SPECIFIC TYPE):
-
VENTILATION:
LOCAL
EXHAUST: - SPECIAL:
-
MECHANICAL(GENERAL):
-
OTHER: -
PROTECTIVE GLOVES:
RUBBER
EYE
PROTECTION:
SAFETY
GLASSES, GOGGLES, OR SPLASH SHIELD
OTHER PROTECTIVE EQUIPMENT:
-
SECTION IX - SPECIAL PRECAUTIONS
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING:
PRODUCT WILL IGNITE IF EXPOSED TO AN IGNITION SOURCE WHILE AT A TEMPERATURE EQUAL TO OR
EXCEEDING THE FLASH POINT SHOW.
OTHER PRECAUTIONS: UNDER NORMAL CONDITIONS THIS PRODUCT IS CONSIDERED TO BE STABLE.
This information is furnished without warranty, expressed or implied, except that it is accurate to the best knowledge of JEEN International Corporation. The data on this sheet relates only to the specific material designated herein. JEEN
International Corporation assumes no legal responsibility for use or reliance upon these data.
PAGE 2 OF 2
24 Madison Road, Fairfield, New Jersey 07004, USA
Tel: 800-771-JEEN (5336), Tel: 973-439-1401, Fax: 973-439-1402,
email:
info@jeen.com
, Website:
www.jeen.com
