Optima DMC-1xxx and DMC-18x2 Command Reference
IP
i
109
IP
FUNCTION: Increment Position
DESCRIPTION:
The IP command allows for a change in the command position while the motor is moving.
This command does not require a BG. The command has three effects depending on the
motion being executed. The units of this are quadrature.
Case 1: Motor is standing still
An IP a,b,c,d command is equivalent to a PR a,b,c,d and BG command. The motor will
move to the specified position at the requested slew speed and acceleration.
Case 2: Motor is moving towards a position as specified by PR, PA, or IP.
An IP command will cause the motor to move to a new position target, which is the old
target plus the specified increment. The incremental position must be in the same direction
as the existing motion.
Case 3: Motor is in the Jog Mode
An IP command will cause the motor to instantly try to servo to a position which is the
current instantaneous position plus the specified increment position. The SP and AC
parameters have no effect. This command is useful when synchronizing 2 axes in which
one of the axis' speed is indeterminate due to a variable diameter pulley.
Warning: When the mode is in jog mode, an IP will create an instantaneous position error.
In this mode, the IP should only be used to make small incremental position movements.
ARGUMENTS: IP n,n,n,n,n,n,n,n or
IPA=n where
n is a signed numbers in the range -2147483648 to 2147483647 decimal.
n = ? Returns the current position of the specified axis.
USAGE: DEFAULTS:
While Moving
Yes
Default Value
In a Program
Yes
Default Format
7.0
Command Line
Yes
Controller Usage
ALL CONTROLLERS
RELATED COMMANDS:
"PF"
Position Formatting
EXAMPLES:
IP 50
50 counts with set acceleration and speed
#CORRECT Label
AC 100000
Set acceleration
JG 10000;BGA
Jog at 10000 counts/sec rate
WT 1000
Wait 1000 msec
IP 10
Move the motor 10 counts instantaneously
STA Stop
Motion
