Revision Information for ECAM Setup Utility
2.04 February 5, 1999
New DMCWIN which adds support for the DMC-1802.
2.02 February 5, 1998
Latest DMCWIN and DMCOCX. The DMC file that was created would
have the
ecam commands repeated multiple times. This has been fixed.
2.01 June 4, 1997
Fixed a bug with the Flying Shear set-up - the master and slave axes
could not be selected. Latest DMCWIN and DMCOCX.
2.00 May 7, 1997
New 32-bit version available. Upgraded to Graphics Server 4.52 and
Spread 2.5. No other changes.
1.04 January 18, 1996
New flying shear algorithms to segregate special cases. Also
fixed a bug with printing the spreadsheet. If the ecam document
was untitiled, the print-out looked funny. This has been
corrected.
1.03 October 2, 1995
An improper calculation of ecam table points was being generated
in some cases.
1.02 August 22, 1995
An improper calculation of ecam table points was being generated
when the slave axis cycle did not end at zero. Also fixed display
of velocity versus interval.
1.01 August 2, 1995
TBPRO5W.DLL was left off the distribution disk. It is now included.
1.00
Initial release.
