E.28
E.29
CHAPTER FOUR
Inspection, Adjustment & Lubrication
The child carrier can be folded for easier transportation or
more compact storage.
Rocket
To fold the Rocket
If the optional stroller handlebar is attached, you can remove it if desired
(refer to the Handlebar section).
1. Remove the wheel(s).
If you need instructions to remove a wheel, see
Check all wheels of
the child carrier before every ride
on pages 3-5.
2. Remove both locking pins (Figure 4.12).
Locking pin
Figure 4.12- Rocket locking pin
for tensioning bar
Tension
bar
Figure 4.13- Rocket tension-
ing bar
The pins are found immediately above the axle tube at the
back of the child carrier. Remove them by pulling towards the
center of the child carrier.
4. Pull each of the folding tension bars (Figure
4.13) forward to fold the child carrier canopy.
5. Fold the child carrier frame gently backward.
Be careful not to catch or pinch any of the child carrier's
fabric parts. If desired, the trailer tongue, or wheel arms
which hold the front wheel in jogger mode, may also be
removed. See
Changing Child Carrier Modes
on
pages 41-42 for instructions for this procedure.
To unfold the Rocket
1. Attach the front wheel or trailer tongue.
For jogger mode, attach the wheel arms and front wheel.
For stroller mode, insert the stroller wheels. For trailer
mode, insert the trailer tongue.
2. Attach both rear wheels.
3. Gently unfold the child carrier back.
Be careful not to catch or pinch any of the child carrier's
fabric parts.
4. Pull both the tension bars (Figure 4.13) back to
open the folding mechanism.
Be careful not to pinch your fingers between the tension
bars and back of the child carrier.
5. Install both locking pins (Figure 4.12).
Make sure they are fully inserted.
6. Check for correct assembly.
Attempt to move the tension bars forward. With the pins
properly inserted, you can not fold the tension bars to
their folded position.
7. Install the handlebar if needed.
FOLDING THE CHILD CARRIER
Folding the Child Carrier
