(800) 631-LOGO
Installation: Floppy Disk for Windows/DOS 3.1
Please read these instructions completely before proceeding.
About Your Media
Your font files have been delivered on MSDOS Floppy Disk, which is formatted as follows:
Format:
DOS
Volume label
FONTS
About the Installation
The installation procedure is simple, but should be performed someone who is familiar with installing or
modifying Windows features.
1. Start
Windows.
2. Install the fonts.
3. Perform post installation duties. These duties consist of testing the font modules on your printer and
making them available for users.
Deciding where to Install Font Files
Windows 3.1 install fonts into its system directory. No decision is required.
Performing the Installation
Please perform the following steps:
1. Start
Windows.
2. Place your distribution disk in a floppy drive.
3. From the Main program group, open the Control Panel application.
4. Choose
Fonts
. This opens the "Fonts" dialog box.
Note: If the font(s) on the diskette are update fonts already installed in Windows, you should use the Fonts
dialog box to remove the installed versions.
1. Click
Add
button. This opens an "Add Fonts" dialog box.
2. In
the
Drives:
section, Double-click the letter which corresponds to the drive in which the diskette has been
placed. Windows displays the hourglass cursor while searching for fonts; it then displays the list of fonts
found on the diskette.
3. Check
the
List of Fonts
box to verify that it corresponds with the list of fonts on your cover letter.
4. Click
the
SelectAll
button to install all of the fonts.
The fonts are now loaded on your system. Perform the post-installation duties outlined below before
proceeding with application work.
0OST
)NSTALLATION $UTIES
Installation verification
This step describes the check for successful down-loading and acceptance of each logo in the distribution. For
each font listed in the cover letter, .
