Spirit Elements Huron Pool Cabana Assembly Instructions Page 8
15.
Position one
angle cut
Side Top
Plate on top of wall
studs so it is flush
with 2x3 wall stud.
Attach by screwing
down into top of wall
frame with 4 - 2"
screws.
16.
Next, attach the
Front Top Plates (2 per side). The
front and rear top plates are angle cut down the length.
Once again, position top plate on wall frame so it is flush.
Front and rear top plates will fit between side top plates.
Attach with 4 - 2" screws per plate.
Complete all
other Top Plate
attachments.
17.
Place
Side Gable Wall so 1x3 framing sits flush with the inside of
the top plate. It should also be centered sideways on the top plate.
Hint: Use a straight edge to check the angle of the gable framing and
top plate. Both angles should line up. Adjust gable accordingly. Attach
with 4 - 2" screws.
Use straight
edge to check
that angle of
gable lines up
with top plate
angle. Adjust
gable for best fit.
Position and attach other
Side Gable Wall.
Page 8
6672 Gunpark Drive, Boulder, Colorado, 80301 | Toll Line: 1.800.511.1440 | Fax: 1.800.511.1421 | cs@SpiritElements.com | SpiritElements.com
Front Top Plate
