8.
Starting at Rear Corner, position a Solid
Wall Panel on top of plywood floor.
Depending on your preference, you may use
a solid or window wall panel in this position.
If using a solid wall, make sure panel is
facing up.
Important -
Make sure all walls are aligned in their
upright position. If not ,water may leak into
your shed. Unsure if panel is facing up or
down? Check siding on window wall
panel to match alignment.
9.
The front and rear wall panels will sit flush at the
end of the plywood floor with the side panels
sandwiching between them.
Note: Siding will overhang the floor by approx. 1/2" but
2x3 wall frame will sit flush on plywood floor.
Outside 2x3 frame of wall panel is flush
with outside of plywood when properly
aligned. Siding will overhang.
1st Rear Wall Panel
10.
Position 1st side wall panel on plywood floor so
once again 2x3 wall plate is sitting flush on floor.
Position panel so 2x3 framing sits flush with rear wall
framing.
1st Rear
Wall Panel
side of sh
ed
Fron
t
Side
rear w
all
side
wall
Side Wall
Panel
When both wall
panels are positioned
correctly, attach
together at top,
middle and bottom of
vertical studs with 3"
screws.
3" screw
Important -
Do not fasten walls to floor
until Step 14.
Page 6
6672 Gunpark Drive, Boulder, Colorado, 80301 | Toll Line: 1.800.511.1440 | Fax: 1.800.511.1421 | cs@SpiritElements.com | SpiritElements.com
2x3
wall
frame
