D+GA Project No. 9926
Manufactured Roof Specialties
16 October 2001
07710 - 3
2.06
ALUMINUM FINISHES:
A.
General: Comply with AMP 501 "Finishes for Aluminum" and AMP 505 "Applied Coatings" for finish designations and
application recommendations, except as otherwise indicated. For components which are assembled or welded in
factory, apply finish after fabrication is completed.
B.
High Performance Coating: AA-C12C42R1x (cleaned with inhibitive chemicals, conversion coated with an acid-
chromate-fluoride-phosphate treatment and painted with organic coating specified below). Apply in strict compliance
with coating and resin manufacturer's instructions using a licensed applicator.
1.
Fluorocarbon Coating: Inhibitive thermo-cured primer, minimum 0.2-mil dry film thickness, and thermo-cured
fluorocarbon coating containing "Kynar 500" resin, minimum 1.0-mil dry film thickness.
2.
Color:
a.
Fascia: Black (to match color of Aluminum Windows and Aluminum Storefront and Entrance System).
b.
Coping: Peterson Aluminum Corporation `Pac-Clad,' "Sierra Tan."
PART 3 - EXECUTION
3.01
INSTALLATION:
A.
General: Comply with manufacturer's written installation instructions and recommendations. Coordinate with
installation of roof deck and other substrates to receive work of this Section, with vapor retarders, roof insulation,
roofing membrane, flashing, and wall construction; as required to ensure that each element of the work performs
properly, and that combined elements are waterproof and weathertight. Anchor products included in this Section
securely to structural substrates, adequate to withstand lateral and thermal stresses as well as inward and outward
loading pressures.
B.
Isolation: Where metal surfaces of units are installed in contact with dissimilar metal or corrosive substrates, including
wood, apply bituminous coating on concealed metal surfaces, or provide other permanent separation as recommended by
aluminum producer.
3.02
CLEANING AND PROTECTION:
A.
Clean exposed metal surfaces in accordance with manufacturer's instructions. Touch-up damaged metal coatings.
B.
Protection: Provide protective measures as required to ensure that work of this Section will be without damage or
deterioration at time of substantial completion.
END OF SECTION 07710
