AD76PLPL.DOC
p. 5 of 14
17. Create a Plan View Frame.
a) Go
to
[Sheet Mgr]
!
[Sheet Styles]
!
[Create/Edit Frame]
i) Press
<Return>
when prompted to Select Objects.
ii)
In the Edit Frame Data dialog box, select `
Pick Origin/Size<<
'
a)
At the Pick Lower Left (Origin) Point command, type in `
int
' and select the lower
left corner of rectangle
A
(as shown in
Figure IV
).
b)
At the Pick Upper Right Point command, type in `
int
' and select the upper right
corner of rectangle
A
.
c)
The Edit Frame Data dialog box will appear again.
(1)
In the Frame Style/Label Data area, change the Type to
Plan
and the
Category to
View
.
(2) Now,
select
Draw Frame
.
(3) Select
OK
to exit out of the Edit Frame Data dialog box and to return to
the drawing.
18. Create a Profile View Frame.
a) Go
to
[Sheet Mgr]
!
[Sheet Styles]
!
[Create/Edit Frame]
i) Press
<Return>
when prompted to Select Objects.
ii)
In the Edit Frame Data dialog box, select `
Pick Origin/Size<<
'
a)
At the Pick Lower Left (Origin) Point command, type in `
int
' and select the lower
left corner of rectangle
B
(as shown in
Figure IV
).
b)
At the Pick Upper Right Point command, type in `
int
' and select the upper right
corner of rectangle
B
.
c)
The Edit Frame Data dialog box will appear again.
(1)
In the Frame Style/Label Data area, change the Type to
Profile
and
the Category to
View
.
(2) Now,
select
Draw Frame
.
(3) Select
OK
to exit out of the Edit Frame Data dialog box and to return to
the drawing
19. Save the drawing using
[File]
!
[Save]
command.
20. Next, save the sheet style by using the
[Sheet Mgr]
!
[Sheet Styles]
!
[Save Sheet
Style]
command. Save the sheet as
PLAN1.DWG
.
NOTE: When the Save Sheet Style dialog box appears, it most likely will default to
c:\sdskdata\sheets\sdsk_I directory. The default directory is based on your preferences.
Preferences are set in
[Sheet Mgr]
!
!
!
!
[Preferences]
.
21. At the Enter Type of Sheet prompt, select `
planprof
'.
a)
At the Pick the Sheet Lower Left Corner prompt, the `rubber band' should display based on the
lower left corner of your tick marks; simply press
<enter>
. If this is not the case, type in `
int
'
and select the lower left corner of your sheet. Use the same procedure for the Upper Right.
PLAN2.DWG
22. Create a new drawing.
a) Use
the
[File]
!
[New]
command.
i)
The Create New Drawing dialog box will appear.
a) Select
`
New Drawing Name
' to get to the Create Drawing File dialog box.
b) Go
to
c:\sdskproj\sheetmgr
c)
Once that folder is opened, type in `
PLAN2
' in the File Name area.
ii) Go
to
[File]
!
[Softdesk Products]
. This will initialize Softdesk.
iii)
At the Select Project dialog box, select `
sheetmgr
'.
iv)
At the Softdesk Products dialog box, select
Advanced Design
.
